Faucet & Sink Repair

Faucet & sink repair in Tampa, FL

Faucet and Sink Repair in Tampa

Dripping taps, weak flow, leaks under the cabinet. Small problems that quietly do real damage to a cabinet base before anyone looks underneath.

30 YearsOf hands-on experience
Licensed & InsuredFlorida CFC1431054
BBB AccreditedA+ rated business
FinancingWisetack, up to $25,000

The hidden cost

The drip is not the problem. The cabinet base is.

A dripping faucet is mostly an irritation and a slow waste of water. A leak under the sink is a different matter, because it happens out of sight, into a chipboard cabinet base that soaks it up and swells. By the time it is visible the cabinet is usually the expensive part of the repair.

Most faucet faults are worn cartridges, seats or O-rings, all inexpensive and quick on a decent quality fixture. Most under-sink leaks are the connections rather than the fixture: hardened supply lines, angle stops that weep once touched, and slip joints on a P-trap that have lost their seal.

Weak flow at a single tap is usually the least serious of the lot. An aerator packed with mineral deposit is a five-minute fix, and in a hard water region like this one it is by far the most common cause.

  • Dripping and leaking faucets
  • Under-sink leaks, traps and supply connections
  • Low flow and aerator problems
  • Cartridge, seat and O-ring replacement

Common faults

What we get called out for

Most of these are one visit and inexpensive parts.

Constant dripping

A worn cartridge, seat or O-ring. Cheap to fix and worth doing, since a steady drip adds up over a year more than people expect.

Damp in the cabinet

Check the supply connections, the angle stops and the trap. Catching this early is the difference between a plumbing repair and a new cabinet.

Weak flow at one tap

Usually a clogged aerator, which is very common in hard water. If cleaning it does not help, the cartridge or valve body may be scaled internally.

Handle stiff or loose

The cartridge or stem is worn. Left alone it eventually seizes or snaps, which turns a simple part swap into a bigger job.

Water around the base

Usually the seal beneath the escutcheon or a loose mounting nut. Water tracking under the deck reaches the cabinet just the same.

Sprayer or diverter failing

Pull-down sprayers and diverters are common wear points, and on many models replaceable without changing the whole faucet.

Our process

How a repair visit goes

Identify the part, price it, fix it.

1

Trace the leak properly

Water travels. A wet cabinet base does not always mean the leak is where the water is sitting, so we find the actual source rather than tightening the nearest fitting.

2

Check the connections while we are in there

Angle stops and supply lines get inspected as a matter of course. If one is close to failing we will tell you, because replacing it now is far cheaper than after it goes.

3

Repair and test under pressure

Parts replaced, then everything run under pressure while we check each joint. We dry the area and check it again before leaving.

Hard water is why this keeps happening

Tampa Bay water is hard, and that has a direct effect on how long fixtures last. Dissolved minerals precipitate out inside aerators, cartridges and valve bodies, which is why flow drops, handles stiffen and seats wear faster here than in soft water regions.

The quickest win is cleaning the aerator. Unscrew it, soak it in vinegar, rinse and refit. That alone restores flow on a surprising number of taps people were about to replace.

If fixtures across the house are scaling repeatedly, the fixtures are not really the problem. Treating the water addresses the cause, and it protects the water heater and appliances at the same time, which is usually where the real money is.

When repair is not worth it

On a good quality faucet, repair almost always wins. Cartridges and seat kits are inexpensive, widely available, and the body of a decent tap outlasts several sets of internals.

On a builder-grade fixture that is already eight or ten years old, the calculation changes. Parts can be hard to source for discontinued models, and the labour to fit them is the same as the labour to fit a new faucet that will not need attention again for years.

We will tell you which of those you have. If a repair genuinely makes sense we will do it rather than sell you a replacement you did not need.

Answers

Faucet and sink repair questions

Drips, hidden leaks, low flow and repair versus replace.

Still have a question?Call or text and talk to a real plumber, not a call center.(813) 576-8639
How much does a faucet repair cost?
Most are among the cheaper jobs we do, since cartridges and seat kits are inexpensive. Our plumbers quote per job after identifying the fault, and you approve the price before work starts. MVP members take 10% off.
My tap drips. Is that really worth fixing?
Yes. Beyond the wasted water, a drip means something inside is worn, and worn parts do not stabilise. The repair is small now and gets no cheaper by waiting.
There is water in the cabinet but I cannot see where from.
That is normal, water tracks along pipes and surfaces before it pools. We trace it to the actual source rather than guessing, which matters because the fix for a trap leak and a supply leak are completely different.
Why is the flow weak at just one tap?
Nine times out of ten it is the aerator, packed with mineral deposit. You can unscrew it and soak it in vinegar yourself. If that does not fix it, the cartridge or valve body is likely scaled internally.
Should I repair or replace my faucet?
Repair on a good fixture, replace on a cheap old one where parts are scarce and the labour is the same either way. We will give you a straight answer rather than defaulting to replacement.

Book a faucet or sink repair

Tell us which fixture, what it is doing, and whether there is any sign of water in the cabinet below.

Call or text(813) 576-8639
HoursMon–Fri 8:00 AM–6:00 PM
Sat by appointment · Sun emergencies
Service areaTampa & the Greater Tampa Area
LicenseCFC1431054